What Is the Key to Maximize the Fuel Efficiency of Start-stop Vehicles?
For Start-stop Vehicles, Install Tuflong batteries designed for Start-stop Systems!
The Key Is Actually in the Battery.The Key to Draw Out the Fuel Efficiency of Start-stop Vehicles
**Frequent Engine Starts…
How Much Can the Battery Withstand?**
Start-stop vehicles start the engine far more frequently than conventional vehicles.
The momentary high current required to crank the starter motor places a significant load on the battery. If a conventional battery—not designed for start-stop systems—is used, it may rapidly lose performance and reach the end of its service life in a short period of time.
**Limited Charging Opportunities…
How Much Can Be Stored While Driving?**
While stopped, the engine is not running and no power is generated.
This means the battery must recharge quickly during the limited time available while driving.
For this reason, the charging performance of the battery is an extremely important factor for start-stop vehicles.
**If Charging Is Insufficient…
Will the Start-stop Function Stop Working?**
When the battery’s charge drops below a certain level while stopped, the start-stop function is automatically canceled and the engine restarts to prevent battery depletion.
In other words, if the battery does not sufficiently recharge while driving, the vehicle cannot deliver its intended fuel efficiency.
What Happens If a Non-Compatible Battery Is Used in an Start-stop Vehicle?
If a battery not designed for start-stop systems is installed, it will deteriorate rapidly.
As a result, its lifespan is expected to be only about one-third that of an start-stop-compatible battery.
In addition, such cases are not covered by warranty, even within the warranty period.
Key Point 1
Charging acceptance performance is up to 1.8 times higher than non-compatible batteries!
Make the most of limited charging opportunities with “super quick charging”!
Thanks to our proprietary additive formulation, the negative active material is made finer, greatly increasing the amount of charge that can be accepted within a certain period of time. By maximizing limited charging opportunities and allowing rapid charging, “super quick charging” reduces the time the alternator needs to operate, thereby contributing to improved fuel efficiency.
Key Point 2
Improve fuel efficiency with “super quick charging”!
Bring out the performance of start-stop vehicles!
By charging quickly during driving, the battery can recover its state of charge even during short trips.
This extends the time until the battery reaches the engine restart threshold after stopping, helping the vehicle draw out its intended fuel efficiency as an start-stop vehicle.
