Handling of Exhaust Vent Cap and Vent Extension Tube for Tuflong EN
For Tuflong EN batteries having vent holes on both the left and right sides of the battery body, an exhaust vent cap is included as standard.
Applicable Models
- ENA345LN09B
- ENA360LN19B
- ENA375LN29B
- ENALN29B
- ENA390LN39B
- ENALN39B
Batteries with a single-hole gas vent design include an extended vent tube.
Applicable Models
- ENALN49B
- ENALN59B
- ENALBN29B
- ENALBN39B
Flow for Checking Exhaust Vent Cap and Vent Extension Tube
How to Install the Vent Extension Tube
1. Insert the vent extension tube into the L-shaped pipe of the vehicle-side vent tube.
(Figure 1)
2. Secure the angled portion of the vehicle-side vent tube’s L-shaped pipe to the vehicle harness or similar component using the included cable tie.
If the L-shaped pipe of the vehicle-side vent tube cannot reach the harness and cannot be secured, firmly fasten the L-shaped pipe to the battery body using tape or similar material.
(Figure 2)
3. Insert the L-shaped pipe of the vent extension tube into the right-side vent hole* of the battery.
After inserting, make sure that the L-shaped pipe of the vent extension tube is firmly inserted into the right-side vent hole of the battery.
(Figure 3)
If the vent extension tube hangs down excessively due to its length, cut the tube to an appropriate length using a cutter.
* When the battery terminals are facing you, the vent hole is located on the right side. (Figure 4)
